![]() The cell size of that raster dataset will be used directly in the analysis, provided the spatial reference of the dataset is the same as the output spatial reference. ![]() If the cell size is specified using a raster dataset, the parameter will show the path of the raster dataset instead of the cell size value. If the cell size is specified using a numeric value, the tool will use it directly for the output raster. If nothing is specified, then the cell size is calculated from the shorter of the width or height of the extent divided by 250, where the extent is in the Output Coordinate System specified in the environment. If the parameter cell size or the environment cell size have not been specified, but the environment Snap Raster has been set, then the cell size of the snap raster is used. If the cell size hasn’t been explicitly specified as the parameter value, it is derived from the environment Cell Size, if it has been specified. The Output cell size can be defined by a numeric value or obtained from an existing raster dataset. Vertical triangles-essentially vertical walls without a roof-are excluded from the rasterization so will not be represented in the output raster. ![]() An output cell will receive a value if the cell center falls within the footprint of one or more input multipatch features otherwise, it will be assigned NoData. The maximum Z value from the points of intersection is assigned to the output raster. To determine the Z value for each cell, a vertical line is extended from the cell center location to intersect the input multipatch features. The output raster stores the Z values of the input multipatch features at each cell center location. Converts multipatch features to a raster dataset.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |